![]() The maximum burst is displayed even when a CF card is not in the camera. ![]() The maximum burst is displayed even when the drive mode is set to (Single) or. With white balance bracketing (p.60), the maximum burst will be 2 shots. The above table's figures for the maximum burst apply when all the captured images have been processed internally and written to the CF card. During continuous shooting, you pop-up or retract the built-in flash or turn the external Speedlite on or off.Right after taking a picture, you change the shooting mode and take pictures immediately.Pressing the shutter button completely repeatedly at short intervals.The following operations will also greatly decrease the maximum burst: ![]() During continuous shooting, the external flash cannot recycle fast enough.In the mode, the built-in flash automatically switches between firing and non-firing as you shoot continuously.The maximum burst may greatly decrease in the following cases: If you stop the continuous shooting, the maximum burst will increase. While you are shooting and the remaining maximum burst is fewer than 9, the viewfinder will display "8", "7", etc. If "9" is displayed, it indicates that the maximum burst is nine or more shots. The number of shots remaining during the maximum burst is displayed on the lower right of the viewfinder. Note that with high-speed CF cards, the maximum burst may be higher than shown in the table below depending on the shooting conditions. maximum burst during continuous shooting is indicated below for each image-recording quality. The maximum burst during continuous shooting depends on the image-recording quality. Nia™ Setting the Image-recording Quality Max. Note that RAW images will not work with direct printing or DPOF. Image processing refers to adjusting the RAW image's white balance, contrast, etc., to create the desired image. Special knowledge is required, but you can use the bundled software to obtain the optimum effect. The RAW assumes that the image will undergo post-processing with a personal computer. A different image-recording quality can be set separately for the Basic Zone modes and Creative Zone modes.On the top LCD panel, you can check the remaining number of images the CF card can record.In the case of monochrome images (p.65), the file size will be smaller so the number of possible shots will be higher.The actual single image size, number of possible shots, and maximum burst will vary depending on the subject, shooting mode, ISO speed, parameters, etc. The single image size, number of possible shots, and maximum burst during continuous shooting are based on Canon's testing standards (ISO 100 with set).The number of possible shots and maximum burst (p.54) apply to a Canon 512MB CF card.Image File Size and CF Card Capacity According to Image-Recording Quality With RAW+7L, the RAW and JPEG images will be saved under the same file No. To record more images on the memory card, select a higher compression 8. For better image quality, select 7 for low compression. ![]() The 7 (Fine) and 8 (Normal) icons indicate the image's compression rate. When you press the shutter button halfway, the image-recording quality will be displayed on the LCD panel.Press the key to select the desired recording quality, then press.► The recording quality screen will appear. Note that lifiM and lifi^+IL cannot be selected in the Basic Zone modes. In the H+IL (RAW+JPEG) mode, the image is recorded in both the RAW and JPEG simultaneously. In the lifiM mode, the captured image will require post-processing with the software provided. The 7L/8L/7M/8M/7S/8S modes record the image in the widely-used JPEG. The asterisk M on the right of the page title indicates that the respective feature is available only in Creative Zone modes (P, Tv, Av, M, A-DEP).For Basic Zone modes, only the image-recording quality (except RAW and RAW+7L), file numbering, and camera setting check will apply in this chapter.This chapter explains the digital image settings for the image-recording quality, ISO speed, white balance, color space, and processing parameters.
0 Comments
Leave a Reply. |